Kodak 4020 Projector User Manual


 
Slide Obstruction in Slide Tray
Conditions for a correct transport cycle
- Check SLIDE LIFTER LEVER. In the up position, the alignment above the CENTER
HOUSING must be 3.8 mm (0.15 in.) with a tolerance of 0.2 mm (0.008 in.). If the
measurement is greater, replace the SLIDE LIFT LEVER.
- Check the CENTER HOUSING for damaged parts such as:
DRIVE RING
GEAR WHEELS
CODER DISK
Inspect whether the parts are complete. Are there damaged or broken teeth on the
wheels? If so, replace them.
SM 2547-1 Service Manual
Kodak AG, Stuttgart 5-29 03/98