Kodak 7020 Projector User Manual


 
28
Lamp setting
Standby Function
1. Projector in Standby:
Press the standby button (3) on the
projector or remote control.
The projection lamp and the fan will be
switched off. The tray remains in its posi-
tion!
In addition on models 4020, 5020, 7020 and
9020 the standby status is indicated by the
red LED (18) flashing!
2. Projector in operation:
Press again the standby button on the
projector or remote control. The presenta-
tion can now be continued.
Standby
The standby function enables you to inter-
rupt and restart at any time during your
presentations.
Standby places the projector in readiness
for operation.
Note (EKTAPRO 4020, 5020, 7020 and
9020):
In any case the projector goes definitely
on standby (independent of which mode
it was in) if the standby key has been
pressed for longer than 2 seconds! If the
projector was on standby it will be
switched on again and will then go
again on standby.
Standby is not possible if the slot for
modules (35) is engaged with the
KODAK EKTAPRO 12/7-Pol Module.
You can run the lamp of your projector in
standard mode, economy mode and also in
high light mode on the models 7020 and
9020.
1. Economy Setting:
Move switch (4) .
2. Standard Setting:
Return the switch (4) to original position.
The economy setting offers you approxi-
mately three times longer life-span by re-
ducing the projection brightness.
The setting can be changed by the lamp
economy switch.
. High light mode (models 7020 and
9020)
Push the switch (4) backwards and for-
wards once within 1 second. This takes the
projector into high light mode. The lamp
display of the lamp currently on (L1 or L2,
(26)) begins to flash. Lamp output is in-
creased by 20%, although this reduces the
lamp life by around 30%! As soon as you
move the switch (4) once again you cancel
the high light mode!
N.B. Projection time must not exceed 1
minute per slide. See special instructions
on page 25.
Note
You can find information on the output
of the projection lamps on page 36.
.
The KODAK EKTAPRO 9020 Slide Projec-
tor has an automatic zero positioning selec-
tor switch (8). When switched on, it auto-
matically returns the tray to the zero
position, via the quickest route, as soon as
the slide gate is empty.
The automatic zero-positioning is particu-
larly useful for presentations with few slides
and in continuous operation (see p. 32).
Automatic zero positioning
(EKTAPRO 9020)
III. With the Autotimer function via IR
remote control (EKTAPRO 7020 and 9020)
Automatic slide shows can be programmed
directly via remote control with the Auto-
timer function. You can input times be-
tween 1 and 60 seconds! Use the number
combinations 601 - 660.
Then use the <*> key to confirm. The first
slide is then transported immediately, the
next one in the preprogrammed time. By
inputting <600> and <*> you switch the
autotimer off again (see also separate man-
ual).
Note
The Autotimer function takes prece-
dence over times which are set on the
built-in timer (model 9020)!
1./ 2.
1.
2.