Filter
Top Products
30
Other projection modes
Random access operation
Your KODAK EKTAPRO Slide Projector
is provided with an automatic lamp
changer module (20) (also available as an
accessory, see page 35).
Should the projection lamp (L1) fail, the
system automatically activates the second
projection lamp (L2). Centring of the lamp is
not necessary because each lamp is prea-
ligned in its own reflector.
Lamp failure is indicated by two red LEDs
(26):
Red LED L1 lit:
Lamp 1 failed
Red LED L2 lit:
Lamp 2 failed
As soon as a failed lamp is replaced the LED
shuts off (for replacement see page 32).
Note (EKTAPRO 7020 and 9020)
If the LED flashes, it means that the projector is in high-light mode.
Any slide can be selected using the KO-
DAK EKTAPRO IR Remote System (avail-
able as accessory, see page 35). Access is
fast, within approx. 3.5 sec: Input the re-
quired slide number to your IR remote con-
trol and confirm using <*>.
The RA operation is ideal for lectures, inter-
active learning programmes and computer
control. For further details, please see the
instructions manual for the IR EKTAPRO
Remote System RA and EKTAPRO IR Re-
mote System RA/LP.
Note (EKTAPRO 7020 and 9020)
RA mode is also possible in the MAS-
TER/SLAVE combination (2 projector
dissolve). You can find further informa-
tion in the separate manual!
Your EKTAPRO Projector is fully compat-
ible with most of the professional AV equip-
ment that is equipped with a 12 or 7 pole
standard interface. A corresponding mod-
ule is available as an accessory to connect
to these systems (see page 35).
You can program new multi-visions as well
as play back shows already programmed on
this system with the connected equipment.
The features standby and random access
can however not be used here. Further
information on module installation and the
operating order of the connected equip-
ment can be found in the corresponding
operating instructions.
EKTAPRO 4020/5020/
7020/9020 Projector:
Lamp failure indicator
EKTAPRO 7020 and
9020: Connection of
devices with 12/7 pin
socket
To check which lamp is active
Switch the lamp economy switch out of its position. The respective lamp LED (L1 or
L2) lights up for a short time.
Mode Priority Lamp L1 (factory setting)
In this mode the projector will automatically go into lamp 1 position after switch-
ing on. This is indicated by a short blinking of the LED L1 when switching the
projector on.
Mode Lamp position on the last active lamp
In this mode the projector stays -even after a lamp change- on the last active
lamp in use after switching the projector back on. At unsupervised continuous
presentation (projection) this has the advantage that an unused spare lamp with
full life time is always available.
Choosing the individual mode
You can switch anytime to the other mode. For this purpose keep the standby
button pressed when switching the projector on