Kodak 750 Projector User Manual


 
Note: An arc correcting magnet is used to make an even flow of elec-
trodes to prevent a partial overheat of the lamp. In the arrangement, as
illustrated, the magnet is installed in such a position that the N-pole of
the magnet is toward you. The condition is similar to that of a lamp
operated in the vertical position.
15. The projector is now ready to operate. Plug in the remote control, if
required.
16. If you notice any damage to your slides it means that your lamp is
not properly adjusted. Please readjust your lamp. See #13.
Installing a New Lamp
12
Reflector
(In Case Of 750W Series)
Xenon Lamp
Arc Correcting Magnet
Arc Correcting Magnet 750W
560W