Filter
Top Products
16
Settings menu
Sources: allows you to assign a particular input to a specific source key on
the remote and enables or disables Autosource. When Autosource is not
checked, the projector defaults to the last-used source. If no source is found,
a blank screen displays. When Autosource is checked, the projector checks
the last-used source first at power up. If no signal is present, the projector
checks the sources in order until a source is found or until power down.
You can use the Source Enable feature to eliminate certain sources from this
search, which will speed the search. By default, the check boxes for all
sources are checked. Uncheck a source’s box to eliminate it from the search.
System
All options in this menu toggle between on and off.
Rear: reverses the image so you can project from behind a translucent
screen.
Ceiling: turns the image upside down for ceiling-mounted projection.
Auto Power: When Auto Power is checked, the projector automatically
goes into the startup state after the projector receives power. This
allows control of ceiling mounted projectors with a wall power switch.
Display Messages: displays status messages (such as “Searching”) in
the lower-left corner of the screen.
Translucent OSD: makes the menus translucent. This prevents the
image from being completely covered by the menus while you are
making image adjustments.
Sleep Timer: allows you to force the projector to automatically shutoff
after 4 hours.
Sources
Settings menu
Source Enable
Source 1
System menu