Filter
Top Products
A-61662 October 2011 6-7
Cleaning the optics Optics include the imaging guides, camera glass covers and
sensors. All of the optics components should be cleaned at the same
time.
NOTE: The lamps are not part of the optics. The lamps (LEDs) should
not be cleaned with wipes or solvents.
Cleaning the imaging guides and camera glass covers
To prevent streaks in images, reduced OCR/ICR/Barcode recognition
rates, blurred images, etc., you should clean the imaging guides every
50,000 pages.
The two imaging guides which are inside black, plastic frames are
located in the top and bottom transport trays. When removing an
imaging guide for cleaning or replacement, the entire assembly
(imaging guide and frame) are removed and replaced as one piece.
Clean the camera glass covers at the same time you clean the imaging
guides.
CAUTION: Do not remove the imaging guide from the black frame.
1. Open the scanner cover.
2. Gently pull the 2 fastening clips that secure the top imaging guide
towards the front of the scanner to release and remove the imaging
guide from the transport.
3. Using a Staticide wipe, clean both sides of the imaging guide. Be
careful not to touch the cleaned glass.
IMPORTANT:Staticide wipes contain isopropanol which can cause
eye irritation and dry skin. Wash your hands with soap
and water after performing maintenance procedures.
Refer to the Material Data Safety Sheet (MSDS) for
more information. The MSDS is available on the
Kodak web site at www.kodak.com/go/MSDS.
Fastening clips (2)