Filter
Top Products
A-61662 October 2011 3-3
Manually feeding
documents
For demonstration purposes, VRS Test Application is used in the
following procedure.
1. Turn on the scanner and wait until the scanner is ready.
2. Turn on the host PC.
3. Launch the scanning application (in this example, VRS Test
Application) and from the Menu bar, select Source>Scanner
(Source = 9000 with VRS with AIPE).
4. When the scanner is connected, select Source>Properties to open
the scanning application’s Scanner Properties window.
5. Select Manual from the Source drop-down box.
6. Lift the skimmer to the up position.
7. Remove any paper from the feeder.
8. Start a scan, either single or batch. The feeder table will move up,
and the Manual Feed LED will light. The scanner motor will start and
beep indicating it is ready for scanning.
9. Carefully insert the page, keeping your hands and fingers away from
the rotating tires on the feed rollers. The scanner will feed the page,
run it through the scanner and generate an image.
NOTE: If you selected batch scan, you can continue to insert
pages, one at a time.
10.When you are finished, press Stop.