Filter
Top Products
10 A-61578 September 2006
Installation Procedures
Follow the instructions for installing the 1394a (FireWire) card and the
Kodak Driver Software before you connect the scanner to the host
computer.
If you want, Kodak Service will install the 1394a (FireWire card) in the
host computer. Kodak takes no responsibility for problems that may be
caused by the installation of this hardware. If the host computer has a
built-in 1394a (FireWire) port, the i1860 Scanner can be connected
using this interface but it is not recommended. Any connectivity or
other problems encountered with this configuration will require that the
card provided by Kodak be installed.
You must install the software on the host computer before you connect
the scanner.
Installing the 1394a
(FireWire) card in the
host computer
Before connecting the FireWire cable, be sure that power to the
scanner is off. See the FireWire instructions packed with the scanner
for connection instructions.
IMPORTANT: Use proper precautions to avoid static when you install
the 1394a card in your computer. Make sure the
computer power cord is disconnected.
Installing the driver
software
1. Insert the installation CD in the CD-ROM drive. The installation
program starts automatically.
2. Follow the on-screen instructions to install the TWAIN Data Source,
ISIS Driver and the Kodak Scan Validation Tool.
3. Shutdown the host computer.