Filter
Top Products
27
Transmit Current Combi/Current Prog/1 SEQ
Transmit the respective data from the editor to the M3. This operation does not write the data
into the M3's internal memory. You'll need to write (save) it if necessary.
Note: These Receive and Transmit commands use KORG SysEx MIDI Dump to send or
receive data, or to synchronize the data between the M3 and the software.
Don’t touch the keyboard or the mouse of your computer while data is being sent or
received. Also, don’t touch the panel switches or the keyboard of the M3.
Import
Loads PCG data from the M3 into the editor.
Save Default
Writes (saves) the global mode Software Setup settings of the editor as the default settings
that will be used when you start up the editor.
Note: These utilities can be selected only in the editor’s global mode Software Setup page.
Select Auto Load File
In the Software Setup tab, use “Load data file automatically” to select the desired file.
Note: Refer to “Load data file automatically.
All Sound Off
Depending on the host application, "hung" notes may have sometime occurred
while operating the host's functions.
If this symptom occurs, please execute the "All Sound Off" command.
Preferences
Global mode Software Setup lets you specify the default settings that M3 Editor will use
when it starts up. These settings will be saved when you execute the UTILITY command Save
Default.
Total Recall & Data Sync Setting
Here you can specify the editor data that will be saved and loaded as part of the song data by
your DAW software. This setting lets you save only the data you need. When M3 Editor starts
up, the types of data that you’ve checked here will also be loaded automatically from the M3
that’s connected to your computer. (In other words, this data will be synchronized.) Since a