Filter
Top Products
-40-
7.8 Example
This example shows how to configure two VLANs with the following setup:
• VID 1 spans ports 2-16 and VID 2 spans ports 1-3, so port 2 and 3 are members of both VLANs
and all 16 ports must be VLAN Egress Tagging enabled.
• Port 1 is the access port for VID 2, so PVID of port 1 must be set to 2.
• Port 2 is the trunk port for VID 1 and VID 2, so the PVID of port 2 must be set to none and
port 2 must be set to accept tagged frames only
• Port 3 is the hybrid port for VID 1 and VID 2, where VID 1 is the untagged VLAN, so PVID
must be set to 1.
• Ports 4-16 are access ports for VID 1.
The following CLI session does the above setup provided that the initial configuration is the default
configuration:
>vlan
VLAN>add 1 2-16
*** Warning: Existing entry overwritten
VLAN>add 2 1-3
VLAN>egresstagging enable
VLAN>pvid 1 2
VLAN>pvid 2 none
VLAN>frame type 2 tagged
VLAN>conf
VLAN Configuration:
Port EgressTagging PVID FrameType
1: enabled 2 All
2: enabled none Tagged
3: enabled 1 All
4: enabled 1 All
5: enabled 1 All
6: enabled 1 All
7: enabled 1 All
8: enabled 1 All
9: enabled 1 All
10: enabled 1 All
11: enabled 1 All
12: enabled 1 All
13: enabled 1 All
14: enabled 1 All
15: enabled 1 All
16: enabled 1 All
Entries in permanent table:
1: 2,3,4,5,6,7,8,9,10,11,12,13,14,15,16
2: 1,2,3
VLAN>