Filter
Top Products
-8-
UTP Connections
The following figure shows a UTP connection from TP port to
another device via a straight-through UTP cable. When TP port of
Port 2 is used, make sure Port 2 SW4 is set to OFF position.
Depending on the configuration switch setting, the operating modes
used for connecting to different devices are shown as follows:
Connected Device SW1 setting Port Operation Mode
10M Ethernet hub AUTO 10BASE-T, half-duplex
100M Fast Ethernet hub AUTO 100BASE-TX, half-duplex
10/100M dual speed hub AUTO 100BASE-TX, half-duplex
10/100M NWay switch AUTO 100BASE-TX, full-duplex
10/100M NWay NIC card AUTO 100BASE-TX, full-duplex
10M Ethernet device Non-auto 10BASE-T, half-duplex
* Note that all hub devices are half-duplex devices.
Compliant UTP Cables
Connection UTP Cable Type Maximum Length
10BASE-T Cat. 3, 4, or 5 100 meters
100BASE-TX Cat. 5 100 meters
When using a straight-through cable for the connection, make sure
the MDI-X to MDI connection rule is followed.