Filter
Top Products
CHAPTER 3 GETTING READY FOR PRINTING
3-2
● Connecting the Printer to Your Network
Perform this procedure in order to connect the printer to the network
hub.
1
Turn the main switch on the printer OFF ( ).
CAUTION
Make sure the main switch is OFF ( ) before connecting the
network cable.
2
Plug the network cable into the Network Interface Connector
which is located on the left side of the printer.
3
Plug the other end of the network cable into the network hub.
4
Turn the main switch on the printer back ON ( | ).
(2) Procedures
● Network Settings [Configuring the IP Address, etc.]
Perform this procedure in order to register the required network
settings.
NOTE
• The IP address to be used for the printer will differ depending upon
your network. Confirm the address that you need to use in advance
with your network manager.
• If you will use a DHCP server to designate the IP address, there is
no need to perform the following procedure because the factory
default for the printer is set for DHCP server configuration.
• The “*” in a list of setting options indicates the current setting.
1
Press the */Menu key.
2
Press the N or M key to select “3. Set/manager”.
Inch specifications
Menu:
3.Set/manager
Metric specifications
Menu:
3.Set/manager
3
Press the Enter key.
4
Use the MNOP cursor keys to input the pin code (the
default setting is qQrR).
Inch specifications
Enter pin code.
_ _ _ _
Metric specifications
Enter pin code.
_ _ _ _
NOTE
The pin code may be changed (see “13. Mgr. code change” on page
5-10).