Filter
Top Products
CHAPTER 5 MANAGEMENT AND SETTING
5-5
● Configuration by manager
1
Press the */Menu key.
2
Press the N or M key to select “2. Set/manager”.
Inch specifications
Menu:
3.Set/manager
Metric specifications
Menu:
3.Set/manager
3
Press the Enter key.
4
Use the MNOP cursor keys to input the pin code (the
default setting is qQrR).
Inch specifications
Enter pin code.
_ _ _ _
Metric specifications
Enter pin code.
_ _ _ _
NOTE
The pin code may be changed (see “13. Mgr. code change” on page
5-10).
5
Press the N or M key to select “1. Set machine”.
Inch specifications
Set/manager:
1.Set machine
Metric specifications
Set/manager:
1.Set machine
6
Press the Enter key.
7
Press the N or M key to select a setting and press the Enter
key.
Inch specifications
Set Machine:
1.Paper width
Metric specifications
Set Machine:
1.Paper width
Configure each item, referring to the following pages:
1. Paper width···Page 5-6
2. Media Type [Pre-set Temp.]···Page 5-6
3. Paper type [Paper material]···Page 5-6
4. Roll end···Page 5-7
5. Auto shutoff···Page 5-7
6. Timer set···Page 5-7
7. Size adjustment···Page 5-8
8. Fusing temp.···Page 5-9
9. Custom paper···Page 5-9
10. Standard size···Page 5-9
11. Auto roll over···Page 5-10
12. Buzzer···Page 5-10
13. Mgr. code change···Page 5-10
* The “*” in a list of setting options indicates the current
setting.
8
To configure another item, return to step 6.
To complete configuration, press the N or M key to select
“End” [“back”] and press the Enter key.
NOTE
• After each item has been configured, press the */Menu key to return
to the “Ready to print.” screen.
• If you make a mistake when configuring an item, press the */Menu
key. The display will return to the “Ready to print.” screen, leaving
the setting unchanged.
9
Press the N or M key to select “End” and press the Enter
key.