Filter
Top Products
LaCie 324i LCD Monitor Troubleshooting
User Manual page 40
Problem Solution
OSD warning OUT OF RANGE
is displayed when powering
on the 324i or changing the
input source. An image may
be poorly displayed with pixels
missing.
✦ Either the signal clock or the resolution is too high. Choose one of the supported modes.
Image is unstable or unfocused
✦ The signal cable should be completely attached to the computer.
✦ Use the OSD Image Adjust controls to focus and adjust the display by increasing or decreasing
the Fine total. When the display mode is changed, the OSD Image Adjust settings may need
to be readjusted.
✦ Make sure your computer’s video output or the video card is compatible with the 324i resolu-
tions.
✦ If your text is garbled, change the video mode to non-interlaced and use a 60Hz refresh rate.
HDMI and/or Component
Video display image is not
sized properly
✦ Use the OSD Component or HDMI Settings/Aspect Ratio control to adjust the image size.
✦ Make sure your display video card and system are compatible with the mode that you have
selected. If necessary, consult the video card or system manual to change the graphics settings.
No signal
✦ Make certain the computer is not in sleep or stand-by mode. Touch the keyboard or mouse to
exit stand-by mode.
✦ If video does not return to the screen, turn the bottom power switch OFF and ON.
Audio is not present from
speakers or headphones at-
tached to the 324i
✦ Verify that your headphone or speaker cable is properly plugged into the 324i audio out port.
✦ For audio from a computer: verify that the computer-to-monitor audio cable is properly plugged
into your computer audio output as well as the 324i audio input.
✦ For Component Audio, verify that the both of the stereo RCA ends are plugged into your source
and the 324i.
✦ The volume may be too low. Check the volume level in the operating system, source, and 324i
audio settings.
✦ The audio output may be muted in your operating system, source, and/or 324i audio settings.