Filter
Top Products
15: Advanced Settings
EDS User Guide 138
Figure 15-5 CLI Configuration
2. Enter or modify the following settings:
Table 15-6 CLI Configuration
Command Line Interface
Configuration Settings
Description
Login Password Enter the password for Telnet access.
Enable Level Password Enter the password for access to the Command Mode Enable level.
There is no password by default.
Quit Connect Line Enter a string to terminate a connect line session and resume the
CLI. Type <control> before any key the user must press when
holding down the Ctrl key. An example of such a string is
<control>L.
Inactivity Timeout Set an Inactivity Timeout value so the CLI session will disconnect if
no data is received after the designated time period. Default is 15
minutes. Enter a value of 0 to disable.
Telnet State Select Disabled to disable Telnet access. Telnet is enabled by
default.
Telnet Port Enter the Telnet port to use for Telnet access. The default is 23.
Telnet Max Sessions Maximum number of simultaneous Telnet sessions. The default is
3 and the maximum is 10.
SSH State Select Disabled to disable SSH access. SSH is enabled by default.
SSH Port Enter the SSH port to use for SSH access. The default is 22.
SSH Max Sessions Maximum number of simultaneous SSH sessions. The default is 3
and the maximum is 10.