Page 5
Mounting to a Single Gang Box
Two mounting holes have been located in the center of the case 2 1/4"
apart for mounting to a single gang wall box. A 7/8" hole has been
placed between the mounting holes that will accept conduit if desired.
Note: If mounting near a ceiling, make sure the top of the single gang
box is at least 2 1/4" away from the ceiling.
Note: Make sure you have at least 16" of side clearance on one side in
order to remove the front panel.
» Remove the two phillips head screws from the left or the right
end cap and remove. Slide the front panel assembly out of the
case and set aside. Remove the desired vent cap that any
» Line the two holes in the case up to the single gang box and
insert proper screws for the single gang box and tighten
securely.
» Slide the front panel display back into the case, replace the
end cap and secure with the two phillips head screws.