Filter
Top Products
Page 7
» Line the two posts from the mounting plate up with the two
holes of the modified end cap. Insert the chase nipples through
the holes of the modified end cap and secure to the mounting
plate with a 15/16" wrench.
» Slide the front panel assemblies in partially. Secure the
required wiring and install the battery if used.
» Slide the front panel assemblies in fully. Install the end caps
and secure each with its two screws.
» Discard or store the two original end caps the modified end
caps replaced.
mounting plate
#10 lock washers
#10 screws
end cap support
chase nipples
modified end caps
DDC4 cases
#10 lock washers
#10 hex nuts