Filter
Top Products
Page 6
Double Mount – Wall
The AT-DDC requires optional mounting kit (SAM0625)
Tools required for mounting the clock:
Flat blade screwdriver
Phillips head screwdriver
15/16" open end wrench
The double wall mount plate attaches to a double or single gang box
installed securely in the wall. Required wiring should be available
through the gang box at time of installation.
» Remove the two chase nipples from the mounting plate posts.
» Secure the mounting plate securely to the gang box with the
proper screws. (not supplied)
Note: The long dimension of the mounting plate must be perpendicular
to the ground to assure proper alignment of wall clocks.
Mounting - Wall
» Remove the two phillips head screws from the left and the
right end caps of the two DDC4 clocks and remove. Slide the
front panel assemblies out of the cases and set aside.
» Place the two DDC4 clocks back to back and secure by inserting
a #10 screw through the two key holes and the two lower
mounting holes using lock washers and nuts supplied with the
mounting kit.
» Attach the modified end cap to the end of the clocks that will
be attached to the wall mount plate using the original end cap
screws.
» Align the holes of the end cap support plate with the holes in
the modified end cap and secure with 4 #6 phillips head screws
(supplied)