Filter
Top Products
Rev. A00 HQ-ST System Manual Page 26 of 32
APPENDIX E: Test that the HQ Site is Properly Set Up and Working: HQ Plus
Installed
1. From the Internet, open a TCP/IP connection to the two ports that are associated with the HQ Plus. If
authentication is enabled the TCP/IP connection will be established, and dropped upon a character being sent.
2. Method - Use HyperTerminal Winsock (See “HyperTerminal” on page 32.) or Telnet (See “TELNET” on page 32.) to
connect to the (WAN) IP: Port (Base). Connection will be for a short time only before Hyperterminal drops the
connection. The (WAN) IP: Port (Base +1) is tested in “Test the End-to-End HQ-ST Link Communications: HQ and ST
Installed” on page 27.
3. This verifies that ST Plus devices should be able to connect and communicate with the HQ Plus, and the HQ Plus
ports are forwarded through the gateway/router.