Filter
Top Products
Table 26. Removal steps of system board, fan assembly, and 34-mm ExpressCard slot
frame (continued)
When installing:
v Before you attach the fan assembly to the computer, apply thermal grease, at
an amount of 0.2 grams, on the part marked a as in the following figure.
Either too much or too less application of grease can cause a thermal problem
due to imperfect contact with a component. You need to peel the thin film off
from the rubber b.
a
b
v Make sure that the fan connector is attached firmly.
8
9
9
Step Screw (quantity) Color Torque
8 M2 × 3 mm, small−head, nylon-coated (1) Silver 0.167 Nm
(1.7 kgfcm)
9 M2 × 5 mm, flat−head, nylon-coated (2) Black 0.167 Nm
(1.7 kgfcm)
Removing and replacing a FRU 121