Filter
Top Products
Diagnostic Error Code FRU/Action
071-199-XXX Audio port test failed, cause unknown
1. See “Undetermined problems” on page 69
2. Flash the system and re-test. See “Updating
(ashing) BIOS from a disc” on page 560
3. Replace component under function test
071-25X-XXX Audio port failure
1. Speakers
2. Audio card, if installed
3. System board
080-000-XXX Game Port interface Test Passed
No action
080-XXX-XXX Game Port interface Error
1. Remove the game port device and re-test the
system
080-195-XXX Game Port interface Test aborted by user
Information only Re-start the test, if necessary
080-196-XXX Game Port interface test halt, error
threshold exceeded
1. Press F3 to review the log le
2. Re-start the test to reset the log le
080-197-XXX Game Port interface test warning
1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 “Using
the Setup Utility” on page 43
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
080-198-XXX Game Port interface test aborted
1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6 “Using
the Setup Utility” on page 43
2. Flash the system and re-test. See “Updating
(ashing) BIOS from a disc” on page 560
3. Go to “Undetermined problems” on page 69
080-199-XXX Game Port interface test failed, cause
unknown
1. See “Undetermined problems” on page 69
2. Flash the system and re-test. See “Updating
(ashing) BIOS from a disc” on page 560
3. Replace component under function test
086-000-XXX Mouse Port interface Test Passed
No action
086-001-XXX Mouse Port interface Presence
1. Mouse
2. System board
086-032-XXX Mouse Port interface Device controller
failure
1. Mouse
2. System board
086-035-XXX Mouse Port interface Reset
1. Mouse
2. System board
086-040-XXX Mouse Port interface IRQ failure 1. Run Setup
2. Mouse
3. System board
086-195-XXX Mouse Port interface Test aborted by user Information only Re-start the test, if necessary
086-196-XXX Mouse Port interface test halt, error
threshold exceeded
1. Press F3 to review the log le
2. Re-start the test to reset the log le
Chapter 7. Symptom-to-FRU index 61