Filter
Top Products
Diagnostic Error Code FRU/Action
220-XXX-XXX Hi-Capacity Cartridge Drive error 1. Remove the Hi-Capacity Cartridge Drive and
re-test the system
301-XXX-XXX Keyboard error 1. Keyboard
2. Check and test mouse
3. System board
301-000-XXX Keyboard Test Passed No action
302-000-XXX Mouse Test Passed No action
302-XXX-XXX Mouse error 1. Mouse
2. Check and test Keyboard
3. System board
303-000-XXX Joystick Test Passed No action
303-XXX-XXX Joystick error Remove the Joystick and re-test the system
305-000-XXX Monitor DDC Test Passed
No action
305-250-XXX Monitor DDC self test failure 1. Run Setup to enable DDC
2. Cable
3. Monitor
4. Video card
5. System board
415-000-XXXModem Test Passed No action
415-XXX-XXX Modem error Remove the Modem and re-test the system
Beep symptoms
Beep symptoms are tones or a series of tones separated by pauses (intervals without sound) during POST.
The following tables describes beep symptoms.
Beep Symptom FRU/Action
2 short beeps CMOS setting error
Perform the following actions in order.
1. Start the Setup Utility program and press F10 to Save
and exit. See Chapter 6 “Using the Setup Utility” on
page 43.
2. Start the Setup Utility program and press F9 to load
defaults and then press F10 to Save and exit.
3. Perform a Boot-block recovery. See “Recovering
from a POST/BIOS update failure” on page 560
.
1 long and 2 short beeps Monitor or video adapter card
error
Perform the following actions in order.
1. Make sure the monitor is properly connected to the
computer.
2. Replace the video adapter card (if present).
3. Replace the system board.
Chapter 7. Symptom-to-FRU index 65