Filter
Top Products
Installing a CD-RW/DVD drive
To install the replacement CD-RW/DVD drive, complete the following steps.
1. Attach the drive-retention clip 1 to the side of the drive.
2. Slide the drive into the CD/DVD drive bay (using the alignment pins 2) until
the drive clicks into place.
3. Install the cover (see “Completing the installation” on page 100).
4. Slide the server into the rack.
5. Reconnect the external cables; then, reconnect the power cords and turn on the
peripheral devices and the server.
Removing a tape drive
The following illustration shows how to remove an optional tape drive from the
server.
1 SAS riser card
To remove a tape drive from the server, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 33.
2. Turn off the server and peripheral devices, and disconnect the power cords and
all external cables.
3. Slide the server out of the rack; then, remove the cover (see “Removing the
cover” on page 37).
4. Open the tape drive tray release latch 3 and slide the drive tray out of the bay
approximately 25 mm (1 inch).
5. Disconnect the power and signal cables from the rear of the tape drive.
90 ThinkServer RD220 Types 3729, 3779, 3797, and 3798: Installation and User Guide