Lenovo 3836 Server User Manual


 
v The first microprocessor must always be installed in microprocessor socket 1.
v When one microprocessor is installed, a heat sink filler is not required for
microprocessor socket 2; however, the air baffle must be installed to provide
proper system cooling.
v Do not remove the first microprocessor from the system board when you install
the second microprocessor.
v When you install the second microprocessor, you must also install additional
memory. See “Installing a memory module” on page 89.
v The first microprocessor voltage regulator module (VRM) is integrated on the
system board.
v When you install a second microprocessor, you must also install the voltage
regulator module (VRM), which comes with the microprocessor option kit, in the
VRM connector on the system board.
v Some models support dual-core microprocessors or quad-core microprocessors.
Do not mix dual-core microprocessors and quad-core microprocessors in the
same system. Install all dual-core or all quad-core microprocessors in the server.
v To ensure proper server operation when you install an additional microprocessor,
use microprocessors that have the same QuickPath Interconnect (QPI) link
speed, integrated memory controller frequency, core frequency, power segment,
internal cache size, and type. You can use the Setup Utility to determine the
specific type of microprocessor that is installed on the system board.
v Mixing microprocessors of different stepping levels within the same server model
is supported. You do not have to install the microprocessor with the lowest
stepping level and features in microprocessor socket 1.
v The microprocessor speeds are automatically set for this server; therefore, you
do not have to set any microprocessor frequency-selection jumpers or switches.
v If the thermal-grease protective cover (for example, a plastic cap or tape liner) is
removed from the heat sink, do not touch the thermal grease on the bottom of
the heat sink or set down the heat sink.
v If you have to replace a microprocessor, call for service.
v To order additional microprocessor options, contact your Lenovo marketing
representative or authorized reseller.
The following illustration shows the location of the microprocessor connectors and
the VRM connector.
100 ThinkServer TD200 Types 3724, 3808, 3809, 3815, 3817, 3824, 3826, 3836: Installation and User Guide