Filter
Top Products
8. Install the new non-hot-swap hard disk drive into a blue bracket by exing the sides of the bracket and
aligning pin 1 , pin 2 , pin 4 , and pin 5 on the bracket with the corresponding holes in the hard disk
drive so that the hard disk drive can be seated in the bracket.
Note: Do not touch the circuit board 3 on the bottom of the hard disk drive.
Figure68. Installing the non-hot-swap hard disk drive into the bracket
9. Slide the new non-hot-swap hard disk drive with bracket into the drive bay until it snaps into position.
Chapter 6. Installing, removing, or replacing hardware 131