Filter
Top Products
10. Align the drive cage pivot pin with the slot 1 in the upper drive cage and
slide the hard disk drive cage into the chassis.
11. Connect the signal cable and the power cable to the new hard disk drive.
12. Press down on the metal latch 2 and pivot the drive cage into place, and
then slide it to the front of the computer until it snaps into position.
Note: There are two arrows, one on the upper drive cage and one on the hard
disk drive cage. The arrows are aligned when the hard disk drive is in
the proper position.
What to do next:
v To work with another piece of hardware, go to the appropriate section.
v To complete the replacement, go to “Completing the parts replacement” on
page 40.
Replacing the secondary hard disk drive
Attention
Do not open your computer or attempt any repair before reading and
understanding the “Important safety information” in the ThinkStation Safety
and Warranty Guide that came with your computer. To obtain a copy of the
ThinkStation Safety and Warranty Guide,goto:
http://www.lenovo.com/support
This section provides instructions on how to replace the secondary hard disk drive.
Not all computers have the secondary hard disk drive.
Figure 22. Installing the primary hard disk drive
Chapter 2. Installing or replacing hardware 29