Filter
Top Products
9. Locate one of the extra five-wire power cables and connect it to the new hard
disk drive.
Note: You might need to disconnect power cables for other hard disk drives
installed in your computer and then rotate the air flow wall outward
for easier access to the rear of the new hard disk drive.
10. Connect the other end of the signal cable to one of the available hard disk
drive connectors on the system board. See “Locating parts and connectors on
the system board” on page 11.
11. Reconnect all hard disk drive power cables that you have removed and then
rotate the air flow wall inward into the computer.
12. Reinstall the front bezel. See “Removing and reinstalling the front bezel” on
page 15.
13. Reinstall the PCI card holder. See “Removing and reinstalling the PCI card
holder” on page 16.
What to do next:
v To work with another piece of hardware, go to the appropriate section.
v To complete the installation or replacement, go to “Completing the parts
replacement” on page 40.
Figure 22. Rotating the air flow wall
Chapter 2. Installing or replacing hardware 27