Filter
Top Products
6. To install a new hard disk drive into the bracket, ex the sides of the bracket properly and align pin 1 ,
pin 2 , pin 3 , and pin 4 on the bracket with the corresponding holes in the hard disk drive. Do not
touch the circuit board 5 on the hard disk drive.
Figure 18. Installing a new hard disk drive into the bracket
7. Connect one end of the signal cable that comes with the new hard disk drive to the rear of the new
hard disk drive.
Note: The signal cable will be different depending on whether you are installing a SATA hard disk
drive or a SAS hard disk drive.
Figure 19. Connecting the signal cable to a SATA hard disk drive
Figure 20. Connecting the signal cable to a SAS hard disk drive
24 ThinkStation User Guide