Filter
Top Products
Diagnostic Error Code FRU/Action
006-197-XXX Diskette interface test warning
1. If a component is called out, make sure it is
connected and/or enabled
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
006-198-XXX Diskette interface test aborted
1. If a component is called out, make sure it is
connected and/or enabled
2. Flash the system and re-test. See “Updating (ashing)
BIOS from a CD-ROM or diskette” on page 139
3. Go to “Undetermined problems” on page 62
006-199-XXX Diskette interface test failed, cause
unknown
1. Go to “Undetermined problems” on page 62
2. Flash the system and re-test
3. Replace component under function test
006-25X-XXX Diskette interface Error
1. Diskette drive cable
2. Diskette drive
3. System board
015-000-XXX USB port Interface Test Passed
No action
015-001-XXX USB port Presence 1. Remove USB device(s) and re-test
2. System board
015-002-XXX USB port Timeout 1. Remove USB device(s) and re-test
2. System board
015-015-XXX USB port External Loopback failure 1. Remove USB device(s) and re-test
2. System board
015-027-XXX USB port Conguration/Setup error 1. Flash the system. See “Updating (ashing) BIOS
from a CD-ROM or diskette” on page 139
2. System board
015-032-XXX USB port Device Controller failure System board
015-034-XXX USB port buffer allocation failure
1. Reboot the system
2. Flash the system and re-test. See “Updating (ashing)
BIOS from a CD-ROM or diskette” on page 139
3. Run memory test
4. System board
015-035-XXX USB port Reset condition detected 1. Remove USB device(s) and re-test
2. System board
015-036-XXX USB port Register error System board
015-040-XXX USB port IRQ failure
1. Run setup and check for conicts
2. Flash the system. See “Updating (ashing) BIOS from
a CD-ROM or diskette” on page 139
3. System board
015-195-XXX USB port Test aborted by user
Information only Re-start the test, if necessary
015-196-XXX USB port test halt, error threshold exceeded
1. Press F3 to review the log le
2. Re-start the test to reset the log le
Chapter 7. Symptom-to-FRU Index 49