Filter
Top Products
5. Remove the retainer bracket from the failing drive and install it on the new optical drive.
6. Slide the new optical drive into the drive bay until it snaps into position.
7. Connect the signal and power cables to the drive.
8. Replace the front bezel.
9. Go to “Completing the FRU replacement” on page 81.
Replacing a memory module
This section provides instructions on how to replace a memory module.
1. Open the computer cover. See “Opening the cover” on page 68.
2. Locate the memory connector. See “System board locations” on page 68.
3. Remove the memory module being replaced by opening the retaining clips as shown.
Chapter 8. Replacing FRUs 75