Filter
Top Products
6. Install the hard disk drive fan assembly onto the hard disk drive cage (see
“Installing the hard disk drive fan assembly” on page 76).
7. Install the hot-swap hard disk drives that you removed from the hard disk drive
cage (see “Installing a hot-swap hard disk drive” on page 51).
8. Install the lower bezel (see “Installing the lower bezel” on page 36).
9. Install the side cover (see “Installing the side cover” on page 33).
10. Lock the side cover if you unlocked it during removal.
11. Reconnect the external cables and power cords; then, turn on the attached
devices and turn on the server.
Removing the front-panel assembly
To remove the front-panel assembly, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 29.
2. Turn off the server and all attached devices; then, disconnect all power cords
and external cables.
3. Unlock and remove the side cover (see “Removing the side cover” on page 32).
4. Remove the lower bezel, and then remove the upper bezel (see “Removing the
two-piece bezel” on page 34).
5. Slide the drives in bay 1 and bay 2 forward slightly (see “Removing a DVD
drive” on page 44 for more information). It is not necessary to remove these
drives.
6. If the server has hot-swap power supplies, remove the power supplies and the
power-supply cage (see “Removing the hot-swap power supply cage” on page
87).
7. Disconnect the front-panel assembly cable from the system board, and note the
routing of the cable (see “System-board internal connectors” on page 19 for the
location of the front-panel connector).
8. Press up on the release tab of the front-panel assembly 1 and pull the
assembly toward the rear of the server; then, remove the front-panel assembly
from the chassis.
9. If you are instructed to return the front-panel assembly, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
Installing the front-panel assembly
To install the front-panel assembly, complete the following steps:
Chapter 6. Installing and replacing customer replaceable units 83