Filter
Top Products
3. Move the jumper from the standard position (pins 1 and 2) to the maintenance
or configure position (pins 2 and 3).
4. Replace the computer cover and connect the power cord. See Chapter 4,
“Completing the parts replacement,” on page 43.
5. Restart the computer, leave it on for approximately 10 seconds. Turn off the
computer by holding the power switch for approximately 5 seconds. The
computer will turn off.
6. Repeat steps 1 through 2 on page 46.
7. Move the Clear CMOS/Recovery jumper back to the standard position (pins 1
and 2).
8. Replace the computer cover and connect the power cord. See Chapter 4,
“Completing the parts replacement,” on page 43.
Chapter 5. Security features 47