Filter
Top Products
Table 20. Removal steps of palm rest assembly with cables (continued)
Note: In models with the ngerprint reader, the sensor is attached to the palm rest FRU. If the ngerprint reader is
defective, you can remove the ngerprint reader by referring to step 8 as shown in the following gure.
5
6
7
6
8
7
When installing: Make sure that all the cables are attached rmly to the system board.
1130 PCI Express Mini Card for wireless LAN
For access, remove these FRUs in order:
• “1010 Battery pack” on page 57
• “1030 Optical drive or travel cover” on page 60
• “1120 Palm rest assembly with cables” on page 74
Table 21. Removal steps of PCI Express Mini Card for wireless LAN
In step 1a and 1b , unplug the jacks by using the removal tool antenna RF connector (P/N: 08K7159) or pick the
connectors with your ngers and gently unplug them in the direction of the arrows.
78 Hardware Maintenance Manual