Filter
Top Products
Chapter 2. Using Your Computer
21
Note:
If you set passwords through the BIOS Setup Utility and put your
computer into sleep mode by pressing Fn + F1, the following describes the
behavior of the computer when you bring it out of sleep mode:
You are prompted to enter the Windows log-on password rather than the
User password to resume operation.
To set a Supervisor Password:
Only a system administrator is able to perform this procedure.
1 Turn on your computer. Press F2, while the initial screen is displayed.
The BIOS Setup Utility screen opens.
2 Select Security, using the cursor directional keys.
3 Select Set Supervisor Password, and press the Enter key. The Set
Supervisor Password window opens.
4 Choose your Supervisor password, which can be from one to eight
alphanumeric characters in any combination. Type it in the Enter New
Password field.
5 Press the Enter key once to move to the Confirm New Password field.
Retype the password you just entered to verify it.
6 Commit your password to memory, and press the Enter key.
7 Press F10 to exit.
8 Select OK in the Setup Confirmation window.
S9-S10 User Guide V1.0_en.book Page 21 Wednesday, July 23, 2008 5:53 PM