Filter
Top Products
FRU tests
The following table shows the test for each FRU.
Table 1. FRU tests
FRU Applicable test
System board 1. Diagnostics --> CPU/Coprocessor
2. Diagnostics --> Systemboard
3. If the docking station or the port replicator is attached
to the ThinkPad Notebook, detach it.
4. Place the computer on a horizontal surface, and run
Diagnostics --> ThinkPad Devices --> HDD Active
Protection Test.
Note: Do not apply any physical shock to the computer
while the test is running.
Power Diagnostics --> ThinkPad Devices --> AC Adapter, Battery
1 (Battery2)
LCD unit 1. Diagnostics --> Video Adapter
2. Interactive Tests --> Video
Audio Enter the BIOS Setup Utility and change Serial ATA (SATA)
setting to Compatibility, and run Diagnostics --> Other
Device --> Conexant Audio
Speaker Interactive Tests --> Internal Speaker
Note: Once Audio test is done, the no sound is heard this
test. In this case, turn off and turn on the computer. Then,
run this test again.
Keyboard 1. Diagnostics --> Systemboard --> Keyboard
2. Interactive Tests --> Keyboard
Hard disk drive or
solid state drive
Enter the BIOS Setup Utility and change Serial ATA (SATA)
setting to Compatibility, and run Diagnostics --> Fixed
Disks
You can also diagnose the drive without starting up the
operating system. To diagnose the drive from the BIOS
Setup Utility, do as follows:
1. Remove any diskette from the diskette drive, and then
turn off the computer.
2. Turn on the computer.
3. While the message, “To interrupt normal startup, press
the blue ThinkVangate button,” is displayed at the lower
left of the screen, press F1 to enter the BIOS Setup
Utility.
4. Using cursor keys, select HDD diagnostic program.
Press enter.
5. Using cursor keys, select Main hard disk drive or
Ultrabay hard disk drive.
6. Press Enter to start the diagnostic program.
Diskette drive 1. Diagnostics --> Diskette Drives
2. Interactive Tests --> Diskette
Optical drive 1. Diagnostics --> Other Devices--> Optical Drive
2. Interactive Tests --> Optical Drive Test
General checkout 49