Filter
Top Products
A total progress bar allows you to audit this process, which will take about 8
minutes. The final recovery disc may be safely removed during this time, but
may also be left in the optical drive since it is not bootable.
7. You will then be prompted to restart the computer. Select Yes. A warning
window appears, giving you one last chance to stop the restart, but disappears
automatically after about 5 seconds. File processing continues in DOS full
screen mode for about two minutes and the computer restarts to the Windows
®
desktop. No user intervention is required (and should be avoided) after this
point.
8. Windows setup continues on the desktop and DOS window for IBM system
setup, with progress measured by a Factory Preinstallation window on the right
side of the screen. The processes are updating installed softwares.
A warning that antivirus software is not installed appears repeatedly in the
system tray, but this should be ignored. The entire process at desktop takes
about 25 minutes.
9. Then the computer restarts, does some more DOS full screen processing, and
restarts again to a Windows desktop where factory preinstallation continues for
about 12 more minutes, another restart to a DOS screen and then back to the
Windows splash screen and back to the desktop for more preinstallation.
This lasts about 10 more minutes and the computer restarts to do NTFS
conversion and then restarts to the OOBE (Out of Box Experience)
environment.
Passwords
As many as three passwords may be needed for any ThinkPad computer: the
power-on password (POP), the hard-disk password (HDP), and the supervisor
password (SVP).
If any of these passwords has been set, a prompt for it appears on the screen
whenever the computer is turned on. The computer does not start until the
password is entered.
Exception: If only an SVP is installed, the password prompt does not appear when
the operating system is booted.
Power-on password:
A power-on password (POP) protects the system from being powered on by an
unauthorized person. The password must be entered before an operating system
can be booted.
Hard-disk password:
There
are two hard-disk passwords (HDPs):
v User HDP—for the user
v Master HDP—for the system administrator, who can use it to get access to the
hard disk even if the user has changed the user HDP
Note:
There are two modes for the HDP: User only and Master + User. The
Master + User mode requires two HDPs; the system administrator enters
both in the same operation. The system administrator then provides the user
HDP to the system user.
Related service information
22 MT 6369, 6370, 6371, 6372, 8741, 8742, 8743, and 8744