Filter
Top Products
If the POST detects a problem, an error message will be displayed on the screen. A single problem can
cause several error messages. When you correct the cause of the rst error message, probably the other
error messages will not be displayed the next time you turn on the computer.
POST error code POST error message Description/Action
00CE Machine Type or Serial Number is INVALID
This error message is displayed when the machine
type or the serial number is invalid.
0210
Stuck key
This error message is displayed when a key is kept
pressed for a long time.
0211
Keyboard not found
This error message is displayed when there is no
keyboard detected.
0135
Fan failure
The system might be overheating.
Press F1 to enter the Setup Utility program. Then
press F10 to save the operation and exit the Setup
Utility program.
Note: If the problem is caused by the
microprocessor fan, pressing F10 will not solve
the problem.
0164 Memory size decreased This error message is displayed when the memory
size has decreased.
Press F1 to enter the Setup Utility program. Then
press F10 to save the operation and exit the Setup
Utility program.
1762
Conguration change has occurred
This error message is displayed when a hard disk
drive or optical drive change has been made.
Press F1 to enter the Setup Utility program. Then
press F10 to save the operation and exit the Setup
Utility program.
1820
More than one external ngerprint reader
is attached. Power off and remove all but
the reader that you set up within your main
operating system.
If more than one external ngerprint reader is
connected to a computer, this error message will
be displayed to inform you to remove all of the
ngerprint keyboards except the one compatible
with the ngerprint application on your computer.
1962
No operating system found. Press any key
to repeat boot sequence.
This error occurs only after the POST is completed.
Press any key to repeat boot sequence.
0162
Setup data integrity check failure Press F1 to enter the Setup Utility program. Then
press F10 to save the operation and exit the Setup
Utility program.
0167
No processor microcode update found
This error message indicates that there is
no microcode update image for the current
microprocessor.
0175
System security - Security data corrupted Press F1 to enter the Setup Utility program. Then
press F10 to save the operation and exit the Setup
Utility program.
18 ThinkServer TS130 Hardware Maintenance Manual