Filter
Top Products
C
ONFIGURING
THE
S
WITCH
5-34
The Differentiated Services Code Point (DSCP) is a six-bit field that is
contained within an IP (TCP or UDP) header. The six bits allow the DSCP
field to take any value in the range 0 - 63 inclusive. When QoS Mode is set
to DSCP, the DSCP Configuration table is displayed, which allows a
priority (normal or high) to be set for each of the DSCP values.
You can use the Prioritize Traffic drop-down list to quickly set the values
in the DSCP Configuration table. Select All Normal Priority to set all
values to normal priority or select All High Priority to set all values to high
priority. Use Custom if you want to set each value individually.
Web – Click QOS, Settings. In QoS Mode, select QoS Diabled, 802.1p, or
DSCP to configure the related parameters.
Figure 5-24 QoS Settings
Security
ACL
This page enables you to set up a management access filter on the switch.
With the Management Access Filter Configuration table, you can create a
list of up to 8 IP addresses or IP address groups that are allowed
management access to the switch through the web interface or SNMP. The
management interfaces are open to all IP addresses by default. Once you
add an entry to a filter list, access to that interface is restricted to the