Filter
Top Products
9
Connecting Network Cable
The Switch support 16 10/100M Ethernet ports and Port 1 ~
port 8 are PoE Enable ports, these PoE port will automatically
activated when a compatible terminal is identified, the Switch
will supply power through the Ethernet port to the connected
PoE device.
For the Legacy devices that are not yet compatible, the PoE
port will not offer the power to this device. This feature allows
users to freely and safely mix legacy and Power over LAN
compatible devices on their network.
The Switch supports 10Mbps Ethernet or 100Mbps Fast
Ethernet and it runs both in half and full duplex mode using two
pair of Category 5 cable.
These RJ45 ports are Auto-MDI type port. The Switch can auto
transform to MDI-II or MDI-X type, so you can just make an
easy connection that without worrying if you are using a
standard or crossover RJ45 cable.
AC Power
The Switch used the AC power supply 100-240V AC, 50-60 Hz.
The power switch is located at the rear of the unit adjacent to
the AC power connector and the system fan. The switch’s
power supply will adjust to the local power source automatically
and may be turned on without having any or all LAN segment
cables connected.