Filter
Top Products
IDENTIFYING EXTERNAL COMPONENTS
This chapter describes the front panel, rear panel, and LED
indicators of the Switch.
Front Panel
The figure below shows the front panel of the Switch.
Figure 3. Front panel of the Switch
LED Indicator:
Comprehensive LED indicators display the status of the switch
and the network (see the LED Indicators chapter below).
PoE Ports (Port 1~8):
These ports are PoE Enable ports, the PoE port will
automatically activated when a compatible terminal is identified,
the Switch will supply power through the Ethernet port to the
connected PoE device.
For the Legacy devices that are not yet compatible, the PoE
port will not offer the power to this device. This feature allows
users to freely and safely mix legacy and Power over LAN
compatible devices on their network
These ports support network speeds of either 10Mbps or
100Mbps, and can operate in half- and full- duplex transfer
modes. These ports also supports automatic MDI/MDIX
crossover detection function gives true “plug and play”
capability, just need to plug-in the network cable to the hub
directly and don’t care if the end node is NIC (Network Interface
11