Filter
Top Products
Card) or switch and hub.
Ethernet Ports (Port 9~16):
These ports support network speeds of either 10Mbps or
100Mbps, and can operate in half- and full- duplex transfer
modes. These ports also supports automatic MDI/MDIX
crossover detection function gives true “plug and play”
capability, just need to plug-in the network cable to the hub
directly and don’t care if the end node is NIC (Network Interface
Card) or switch and hub
Note: When the port was set to “Forced Mode”, the Auto
MDI/MDIX will be disabled.
Rear Panel
Figure 4. Rear panel of the Switch
AC Power Connector:
This is a three-pronged connector that supports the power cord.
Plug in the female connector of the provided power cord into
this connector, and the male into a power outlet. Supported
input voltages range from 100-240V AC at 50-60Hz.
Reset:
The Reset button is to reset all the setting back to the factory
default.
Note: Be sure that you recorded the setting of your device,
else all the setting will be erased when pressing the
“Reset” button.
12