Filter
Top Products
N_One Wireless Broadband Router
For best Wireless reception and performance, the Wireless
Broadband Router should be positioned in a central location
with minimum obstructions between the Wireless Broad-
band Router and the PCs.
Also, if using multiple Access Points, adjacent Access
Points should use different Channels.
2. Connect LAN Cables
Use standard LAN cables to connect PCs to the Switching Hub ports on the Wire-
less Broadband Router. Both 10BaseT and 100BaseT connections can be used
simultaneously.
If required, connect any port to a normal port on another Hub, using a standard
LAN cable. Any LAN port on the Wireless Broadband Router will automatically
function as an "Uplink" port when required.
3. Connect WAN Cable
Connect the DSL or Cable modem to the WAN port on the Wireless Broadband
router. Use the cable supplied with your DSL/Cable modem. If no cable was sup-
plied, use a standard cable.
4. Power Up
Connect the supplied power adapter to the Wireless Broadband Router. Use only
the power adapter provided. Using a different one may cause hardware damage.
5. Check the LEDs
• The PWR LED should be ON.
• For LAN (PC) connection, the LAN LED should be ON (provided the PC is also
ON.)
• The WLAN LED should be ON if wireless clients are connected.
• The WAN LED should be ON if DSL or Cable modem is power ON.
• The Net LED may be OFF. After Setup Wizard configuration, it should come ON.
For more information, refer to Front-mounted LEDs in Chapter 1.
10