Filter
Top Products
5 Close the upper front door.
6 Touch Continue.
200–201 paper jams
1 Open the upper front door.
CAUTION—HOT SURFACE: The inside of the printer might be hot. To reduce the risk of injury from a hot
component, allow the surface to cool before touching.
2 Open the lower front door.
Note: To avoid overexposing the photoconductor units, do not leave the front door open longer than 10 minutes.
3 Pull the paper forward if it is lodged under the photoconductor units.
Note: You may need to remove the photoconductor units if the paper is lodged too tightly under them.
4 Remove each photoconductor unit, and then place it on a flat surface.
5 Remove the jammed paper, and then replace each photoconductor unit.
6 Close the lower front door.
7 Close the upper front door.
8 Touch Continue.
Troubleshooting
265