Filter
Top Products
16
INSTALLATION
If the screen is not parallel to the wall
NOTE
If the top of the screen is tilted to the wall, add space steels at the top and, if the bottom of
screen is tilted to the wall, add magnets at the bottom to make the screen parallel to the wall.
If the screen does not stay level
If you want to move the screen vertically or if it does not stay level, remove the
screen and adjust the bracket on the back. Loosen the six screws of the bracket to
move it and fasten the screws again.
(4 mm of distance between slots = 0.14°)
(Hang the screen again following steps 9-12.)
NOTE
When you fix a bracket screw to a lower hole, the screen goes up. When you fix a bracket
screw to a higher hole, the screen goes down.
The left and right bracket assemblies are different as shown below.
Left
Right