Filter
Top Products
2. LG Network Storage Installation
1
<Web Menu>
Web menu is used to access the web page.
<Network Folder>
Network folder is used to open the network folder. Double-clicking the left button of the
mouse will open the network folder.
<FTP server>
This is used to log on to the FTP server.
<NAS detector>
The NAS Detector program is run to change the IP address of the LG Network Storage.
This menu will properly function only after the NAS Detector has been completely
installed.
<NAS Wakeup>
This function is used to change the LG Network Storage mode from maximum energy
save mode to normal mode. This procedure usually takes approximately 1 minute.
<Choose a NAS>
Using one LG Network Storage will automatically set up an IP address for the NAS
monitor. However, using multiple LG Network Storages may forward too many messages
to the NAS Monitor while not knowing to which LG Network Storage the message is
being sent at the selection of a menu. Therefore, designating one LG Network Storage
may allow information for that specific LG Network Storage to be processed.
<View the Last Message>
This menu shows the last message sent.
<Hide Message>
This menu hides the message sent from LG Network Storage.