Filter
Top Products
2
IMPORTANT SAFETY INSTRUCTIONS
WARNING: Do not attempt to service this product yourself except to replace
the battery. Opening or removing the cover may expose you to dangerous
voltages, even when the AC cord is disconnected from the electrical outlet.
Refer all servicing to qualified service personnel.
1. SAVE THESE INSTRUCTIONS. THIS MANUAL CONTAINS IMPORTANT
SAFETY INSTRUCTIONS. Read all safety and operating instructions before
operating the Uninterruptible Power System (UPS). Adhere to all warnings
on the unit and in this manual. Follow all operating and user instructions.
2. This product is designed for Commercial/Industrial use only. It is not
intended for use with life support and other designated “critical” devices.
Maximum load must not exceed that shown on the UPS rating label. If
uncertain, consult your dealer. See Limited Warranty.
3. WHEN REPLACING THE BATTERIES, USE THE APPROPRIATE
LIEBERT-APPROVED REPLACEMENT BATTERY KIT. PROPER
DISPOSAL OF BATTERIES IS REQUIRED. REFER TO YOUR LOCAL
LAWS AND REGULATIONS FOR DISPOSAL REQUIREMENTS.
4. Always turn off the UPS and unplug it before starting the battery
replacement procedure. To replace batteries, refer to the battery
replacement procedure. If you feel unqualified to replace the batteries, do
not open the battery door. Refer all servicing to qualified service personnel.
5. CAUTION: Do not open or mutilate the batteries. Released electrolyte is
harmful to skin and eyes and may be toxic.
6. The mains supply socket or means of isolation must be within 2 meters of
the equipment and accessible to the operator. The UPS is designed for data
processing equipment.
7. The UPS comes with two output power leads with molded connectors - do
not modify these leads. Consult dealer if connector does not match the load
socket. UPS must be grounded at all times while in use. Turn UPS off
before unplugging it, or the safety earth will be removed.
8. The UPStation GXT™ models 700 VA, 1000 VA, 1500 VA, and 2000 VA are
not supplied with an input power lead for connection to the mains supply
socket. Use the input mains supply power lead from your data processing
equipment to connect the UPS to the mains supply. For the 3000 VA model,
use the supplied 16 ampere rated input mains supply lead. For UK supply
systems, consult a qualified electrician to connect the lead supplied for the
3000 VA model to the mains supply.
CAUTION: The UPS and the connected load combined total earth leakage
current must not exceed 3.5 milliamperes. If the connected load earth
leakage current is likely to exceed 2.0 milliamperes or you are unsure, then
convert the input lead attachment to either a fixed wiring installation or an
industrial plug/socket (e.g. CEE 17 connector). This task should be carried
out by a competent electrical engineer who is conversant with local electrical
codes/regulations.