Liebert PSP Power Supply User Manual


 
9
INSTALLATION
1. Visually inspect the UPS for freight damage. Report damage to the
carrier and your local dealer, Liebert representative or the Liebert
Worldwide Support Group.
2. Decide where to place the PowerSure PSP. Install the UPS indoors
in a controlled environment, where it cannot be accidentally turned
off. Place it in an area of unrestricted airflow around the unit, away
from water, flammable liquids, gases, corrosives, and conductive
contaminants. Maintain a minimum clearance of 100mm (4 in) on
each side of the UPS. Maintain an ambient temperature range of
0°C to 40°C (32°F to 104°F).
3. Plug the PowerSure PSP’s attached 1.8m (6-ft.) power cord into an
AC outlet.
4. Plug any computers and monitors into the orange battery backed up
receptacles.
Other office machines that do not exceed the capacity of the UPS—
inkjet printers, scanners and fax machines—may be plugged into
either of the two (2) black receptacles, which provide surge protec-
tion only.
NOTE
UPS operation in temperatures above 25°C (77°F) reduces
battery life.
185-270V
185-280V
175-270V
175-280V
Refer to user's manual
for voltage setting
Circuit Breaker
Push to Reset
Surge Protection Only
CAUTION: Risk of electric shock.
Refer to bottom of unit for cautionary marking.
Battery Back-up + Surge Protection
Plug this type of equipment into black
receptacles ONLY
Plug computers, monitors & network hubs
into orange receptacles
Inkjet
printer
Scanner Fax
machine