Filter
Top Products
Section 5 IP Access Configuration & Operation
30
Remote Console Status Line
Status line
Shows both console and the connection state. The size of the remote screen is displayed. The
example below was taken from a Remote Console with a resolution of 1024 x 768 pixels. The
value in brackets describes the connection to the Remote Console. Norm means a standard
connection without encryption, SSL indicates a secure connection.
Furthermore, both the incoming (In :) and the outgoing (Out :) network traffic are visible (in
kb/s). If compressed encoding is enabled, a value in brackets displays the compressed transfer
rate.
For more information about Monitor Only and Exclusive Access settings, see the relevant
section 5.7.4.
Section 5 IP Access Configuration & Operation
31
5.7. Menu Options
5.7.1. Remote Control
KVM Console
To open the KVM console, click either the menu entry on the left or on the console picture on
the right. To refresh the picture, click on the Refresh button.
Remote Power
Future firmware updates will allow you to control external RS232 controlled power control
distribution units. Please contact LINDY for further information regarding compatibility,
connection and configuration of both LINDY and third party power control distribution units.
Should you wish to connect a remote power outlet then LINDY would recommend you to use IP
managed power strips that can be found in the network section of the LINDY website, i.e.
LINDY No. 32657, 32658, 32656, 32654, 32653, 32414, 32415
Technological
progress
The KVM over IP Module and its software and firmware are subject to technological
progress and are being continuously upgraded accordingly. Therefore minor changes
compared to the descriptions in this manual may be found, especially for the design of the
screens and menus.