Filter
Top Products
- 8 -
Verification of the Proper Installation for Windows NT 4.0
1. Double click My Computer/Control Panel/SCSI Adapters.
2. Highlight Silicon Image Sil-3112 SATA Raid Controller and click Properties.
This device is working properly
is displayed in the dialog box, the driver has been
correctly installed.
4.4. Windows 2000 Driver Installation
For New Windows 2000 Systems
1. After the
SATA RAID PCI Host Adapter
and attached drives are configured, follow
Microsoft procedures to install Windows accordingly.
2. At the Windows Set-up screen, press F6 to specify and add the driver.
3. Insert the Driver diskette. Press S, then press Enter.
4. Select Silicon Image Sil-3112 SATA Raid Controller Driver and press Enter.
5. Press Enter to continue and follow on-screen instructions to complete installation.
Add Windows 2000 Driver on Original Booting Device
1. After the
SATA RAID PCI Host Adapter
and attached drives are configured, boot up
Windows.
2. At the Found New Hardware Wizard, click Next.
3. Select Search for a suitable driver for my device (recommended) and click Next.
4. Insert the Driver diskette into the floppy drive, check Specify a location, uncheck the
other boxes, click Next, type in A:\. Click OK and then Next to continue.
5. If the Digital Signature Not Found message appears, click Yes. (Note If prompted for
Windows 2000 CD-ROM, insert the CD and click OK. Type in D:\I386, click OK and
Finish. (assuming D: is your CD-ROM drive))
6. Click Finish.
4.5. Windows XP Driver Installation
For New Windows XP Systems
1. After the
SATA RAID PCI Host Adapter
and attached drives are configured, follow
Microsoft procedures to install Windows accordingly.
2. At the Windows Set-up screen, press F6 in order to specify and add the driver.
3. Insert the Driver diskette. Press S then press Enter.
4. Select Silicon Image Sil-3112 SATA Raid Controller Driver and press Enter.
5. Press Enter to continue and follow on-screen instructions to complete Windows XP