Filter
Top Products
The Cable/DSL Wireless-Ready Router’s Front Panel LEDs
Diag Red. The Diag LED illuminates when the Router goes
through its self-diagnosis mode during boot-up and restart. It
will turn off upon successful completion of the diagnosis. If
this LED stays on for an abnormally long period of time,
refer to the Troubleshooting section. During firmware
upgrades, this will also flash.
Power Green. The Power LED illuminates when the Router is pow-
ered on.
Full/Col Green. The Full/Col LED also serves two purposes. If this
LED is continuously illuminated, the connection made
through the corresponding port is successfully running in
Full Duplex mode. If the LED is flickering, the connection is
experiencing collisions. Infrequent collisions are normal. If
this LED is flickering too often, there may be a problem with
your connection. Check the Troubleshooting section if you
think there is a problem.
Link/Act Green. The Link/Act LED serves two purposes. If the LED
is continuously illuminated, the Router is successfully con-
nected to a device through the corresponding port (1, 2, 3 or
4). If the LED is flickering, the Router is actively sending or
receiving data over that port.
100 Orange. The 100 LED illuminates when a successful
100Mbps connection is made through the corresponding
port.
4
Figure 2-3
The Wireless PC Card (not included)
To add wireless capabilities, a WPC11 (sold separately) is required.
Power off the Router. Insert the WPC11 in the manner shown above
in the warning label. Push the WPC11 into the BEFSR41W until it
is securely held in place by the PCMCIA Slot.
5
The Reset Button
To use the Reset button:
Unplug the power adapter from the Router. Then, plug the power
adapter back into the Router. Press the Reset button. The Diag LED will flash
after three seconds.
To restore the factory default settings, Unplug the power adapter from the
Router. Press the Reset button and hold for three seconds while plugging the
power adapter back into the Router.
Figure 2-2
Instant Broadband
TM
Series
EtherFast
®
Cable/DSL Wireless-Ready Router with 4-Port Switch
The Wireless-PC Card
The Reset Button